c822-98中文版-混凝土管及相关产品的标准术语.docVIP

C 822 PAGE 514 Designation: C 822 - 98ε1 PAGE 507 Standard Terminology Relating to Concrete Pipe and Related Products This terminology is under the jurisdiction of ASTM Committee C-13 on Concrete Pipe and are the direct responsibility of Subcommittee C13.10 on Correlation and Editorial.Current edition approved Dec. 10, 1998. Published March 1999. Originally published as C 822 - 75. Last previous edition C 822 - 93. This terminology is under the jurisdiction of ASTM Committee C-13 on Concrete Pipe and are the direct responsibility of Subcommittee C13.10 on Correlation and Editorial.Current edition approved Dec. 10, 1998. Published March 1999. Originally published as C 822 - 75. Last previous edition C 822 - 93. This standard is issued under the fixed designation C 822; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C822刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense.本标准已获得批准供（美国）国防部各部门使用。 ε1 Note—Editorial changes were made throughout in April 1999.注——于1999年4月进行了编辑性修改。 1. Referenced Documents1. 参考文件 1.1 ASTM Standards:ASTM 标准： C 497 Test Methods for Concrete Pipe, Manhole Sections, or Tile Annual Book of ASTM Standards, Vol 04.05.混凝土管、检查井制件或瓦罐的试验 Annual Book of ASTM Standards, Vol 04.05. 2. Terminology2. 术语 absorption—the increase in weight of concrete resulting from the penetration of water into the concrete.吸水性——由于水渗入混凝土导致混凝土重量的增加。 absorption test—a test made to determine the absorption of concrete.吸水性试验——用于确定混凝土吸水性的试验。 admixture—a material other than water, aggregates, cement and fibre reinforcing used as an ingredient of concrete and added to the batch immediately before