ANSYS单元生死功能模拟门式刚架施工.doc

! ANSYS单元生死功能模拟门式刚架施工 ! Simulate the construction of a frame with the element active/kill ! function of ANSYS ! 施工分为三步 ! The construction is divided into 3 steps ! 1: 建立立柱和临时支撑 ! 1: Install the column and temporary support ! 2: 安装横梁 ! 2: Install the beams ! 3: 去掉临时支撑 ! 3: Remove the temporary support ! 作者：陆新征，清华大学土木系 ! Author: Lu Xinzheng Dept. Civil Engrg. of Tsinghua UniversityFINISH /CLEAR /UNITS,SI /PREP7 !* SECTWIDTH=300 !构件截面宽度300MM SECTHEIGHT=600 !构件截面高度600MM SECTAREA=SECTWIDTH*SECTHEIGHT SECTIYY=SECTWIDTH**3*SECTHEIGHT/12. SECTIZZ=SECTWIDTH*SECTHEIGHT**3/12. SPAN=24E3 !跨度24M COLUMNHEIGHT=8E3 !柱子高度8M SLOP=3E3 !顶部斜坡3M ET,1,BEAM4 R,1,SECTAREA,SECTIYY,SECTIZZ,SECTHEIGHT,SECTWIDTH, , MP,EX,1,30E3 MP,NUXY,1,0.2 MP,DENS,1,2500E-12 K,1, K,2,SPAN/2,0 K,3,SPAN K,4,0,COLUMNHEIGHT K,5,SPAN,COLUMNHEIGHT K,6,SPAN/2.,COLUMNHEIGHT+SLOP Left column 左立柱L,1,4 !． L,2,6 !临时支撑 Temporary support L,3,5 !右立柱 Right Column L,4,6 !左横梁 Left Beam L,5,6 !右横梁 Right Beam LESIZE,ALL, , ,1 , , , , ,1 LMESH,ALL /ESHAPE,1.0 FINISH /SOLU CNVTOL,F,,0.001,2, NLGEOM,1 AUTOTS,0 NSUBST,3, , ,1 DK,1,ALL DK,3,ALL DK,2,ALL ACEL,0,9.8E3, !杀死横梁 ! Kill Beams EKILL, 4 EKILL, 5 SOLVE FINISH /POST PARSAV, ALL, PARAM, TXT, FINISH /SOLU ANTYPE,,REST, PARRES, CHANGE , PARAM, TXT, !激活横梁 ! Active beams EALIVE,4 EALIVE,5 SOLVE FINISH /POST PARSAV, ALL, PARAM, TXT, FINISH /SOLU ANTYPE,,REST, PARRES, CHANGE , PARAM, TXT, !激活横梁 ! Active beams EALIVE,4 EALIVE,5 !杀死临时支撑 ! Kill Supports EKILL,2 SOLVE FINISH /POST /DSCALE,1,10 /REPLOT