毕业论文---基于单片机的霓虹灯控制器的设计89205.pdfVIP

基于单片机的霓虹灯控制器的设计 摘 要 本设计采用 AT89C52 单片机实现对霓虹灯的控制。系统由红外遥控模块、单片 机控制模块、显示模块、语音模块四部分组成。红外遥控模块分红外发射部分和红 外接收部分，通过单片机译码后，取出红外发射按钮的地址，从而实现红外遥控器 对霓虹灯显示图案的远距离控制。红外接收管也只占用一个 IO 口。显示部分为 16× 16 的点阵模块，通过单片机控制显示不同的图案以及想要的文字，并让字能够移动、 暂停，以及从当前文字切换其它文字。语音模块采用的语音芯片是 ISD1730，可以 录制想要的语音，通过录音可以对设计进行介绍。语音的播放支持暂停、下一首、 调节音量和复位。由于单片机的 IO 口不够用，本设计采用74HC154 对其扩充，将四 线扩充到十六线。该系统具有电路结构简单、易操作、成本低等优点，具有较强的 实用价值。 关键词：单片机；红外遥控；点阵；译码器；霓虹灯 第 1 页 共 47 页 The Design of the Neon Lights controller Based on SCM Abstract This design uses the AT89C52 single chip microcomputer to control the neon lights. The system is composed by the infrared remote control module, the single-chip microcomputer control module, the display module and the speech module. Infrared remote control module is divided into the infrared transmitter and infrared receiver parts. After decoding through the single chip microcomputer, the infrared emission button address can be taken out in order to realize the remote control of infrared neon lights display. The infrared receiving tube only takes up one IO port. The display part uses the dot matrix module with 16 plus 16, through the single-chip control, it can display different patterns and the text, and make the word to move, pause, and switch from the current text to the other. The voice module uses voice chip ISD1730, which can record the desired voice, which can be played to introduce the design. It is support for pause, next, adjust the volume and reset of the voice playback. Due to the IO port of the microcontroller is not enough, this design uses a 74HC154 to expand the IO port, which is expanding the four-line to 16-line. The system has a