高速轴承应用讲解.pptVIP

高速轴承的应用 高速轴承的界定 ●两种定义 sd.n值≥1×106r/mnmm ●转速超过先行极限转速1倍以上 ●超高速轴承:dn值≥2×106r/mnmm 应用场合 ●火箭发动机轴承dn值:160万-200万 飞机发动机主轴轴承 汽车燃气轮机轴承 ●数控机床,电主轴 ●高速离心机 ●高速火车 ●高速摄影机 牙钻轴承dmn值:160万左右 高速带来的问题 ●润滑剂飞散,难以附着 ●离心力使接触应力急剧增大~(un)2 ●摩擦增大,发热量激增 适应高速要求的轴承结构 高速轴承首先是精密轴承 ●深沟球轴承 ●角接触球轴承▲ ●短圆柱滚子轴承 ●圆锥滚子轴承 One-piece cage (ball retainng guided on the outer ring Outer ring One-piece on the outer ring her ring Inner ring Bearings of this series Ha uP F2 and abec 6 619 618 Bearing series S GMN standard spindle bearin Bearing series SM… Geometry of inner ring modified for extremely high speeds duced load rating and static rigidit mpared to bearing series s Equal or higher service life as with bearing series S.. due to lower friction Non-separable type Bearing series SH A special design ot series SM Oil inlet Oil outlet Optimised oi feedin and on inner ring ● speed coefticient nx 2. 4 105 mm/min reliably possible with h cooling lubrication Open Available only on request Bearing series SM A special design of ● ptimised for throw-away lubrication and做x tremely high speeds, it eliminates the need for the high oil feed, seal, and cooling system com plexity of an Dil injection system. High degree of reliability in operation is ensured by farce- feed lubrcation through the shaft and the bearing inner ring. Oil supply Available only on request 1XGMN轴承(表2 袤2GMN轴·值 结系到 备注 1x10mm.r/min 外引导 SH6000CTA 200 1 SHGJOJCTA 25 内引导 SGOOKCTH l30 BTE〔cT 1.06内分离转构 外引哥 S6CC0ETA I45 内引导 l70 L.0 S62oDfTA 0.a5 外引导 数3SNFA轴示d·值 结构系列 值 1E0l小 备注汽 1X10+m E 1.07c0系列 同z≌$的 70系列 L75 内国为 分离结构 同zYS的 VEX 225 1,257c00系列 阿zYS的 0397c00系列 同Z￥5的 VEX t.50系列 用腐瓷球