面试问题库Top300+项CCIE面试名问题(Part2).docVIP

OSPF ??How do I change the reference bandwidth in OSPF? 如何更改OSPF中的参考带宽？ ? ??How does OSPF calculate its metric or cost? OSPF如何计算其度量或成本？ ? ??What algorithm is used by OSPF if equal cost routes exist? 如果存在同等成本的路线，OSPF使用什么算法？ ? ??Are OSPF routing protocol exchanges authenticated? OSPF路由协议交换是否进行了认证？ ? ??What is the link-state retransmit interval, and what is the command to set it? 链路状态重传间隔是多少，设置命令是什么？ ? ??What is the purpose of the variable IP-OSPF-Transmit-Delay? 可变IP-OSPF-Transmit-Delay的作用是什么？ ? ??Are the multicast IP addresses mapped to MAC-level multicast addresses? 组播IP地址是否映射到MAC级组播地址？ ? ??Does the Cisco OSPF implementation support IP TOS-based routing? Cisco OSPF的实施是否支持基于IP TOS的路由？ ? ??Does the offset-list subcommand work for OSPF? offset-list子命令是否适用于OSPF？ ? ??Can I use the distribute-list in/out command with OSPF to filter routes? 可以使用OSPF配置的分发列表in/out命令来过滤路由吗? ? ??Why do I receive the “cannot allocate router id” error message when I configure Router OSPF One? 为什么在配置路由器OSPF One时收到“无法分配路由器ID”错误消息？ ? ??Why do I receive the “unknown routing protocol” error message when I configure Router OSPF One? 为什么在配置路由器OSPF One时收到“未知路由协议”错误消息？ ? ??Do I need any special commands to run OSPF over BRI/PRI links? 是否需要任何特殊命令通过BRI / PRI链路运行OSPF？ ??Do I need any special commands to run OSPF over asynchronous links? 是否需要任何特殊命令通过异步链路运行OSPF？ ? ??Why are OSPF show commands responding so slowly? 为什么OSPF显示命令响应如此缓慢？ ? ??What does the clear ip ospf redistribution command do? Clear IP OSPF重分发命令是做什么的? ? ??Does OSPF form adjacencies with neighbors that are not on the same subnet? OSPF会否与不在同一子网上的邻居形成邻接关系？ ? ??How often does OSPF send out link-state advertisements (LSAs)? OSPF发送链路状态通告（LSA）的频率如何？ ? ??How do I stop individual interfaces from developing adjacencies in an OSPF network? 如何阻止各个接口在OSPF网络中建立邻接关系？ ? ??Why is it that my Cisco 1600 router does not recognize the OSPF protocol? 为什么我的Cisco 1600路由器不能识别OSPF协议？ ? ??Why is it that my Cisco 800 router does not run OSPF? 为什么我的Cisco 800路由器不运行OSPF？ ? ??