八路循环彩灯电路设计.docx

八路循环彩灯电路设计 八路循环彩灯电路设计 摘要：灯光的闪烁和流动可以用于各种各样的装饰，例如电子门标、广告装饰等。灯 光的流动总是特别吸引别人的注意力。在夜晚，在城市的街头，当广告牌上的灯光流动 起来时，城市就会马上变得生动起来。我所设计的彩灯控制电路是原理很简单的一种利 用大学所学到的数电知识制成。只要了解几种集成电路便可轻松明白它的原理。做好的 彩灯可以放在室内，主人会感到温馨;放在餐厅等地方可以增加氛围。 本文基于电子线路CAD常用软件Protel99SE设计了一个简单的循环彩灯电路，各 路彩灯由发光二极管模拟代替。采用555定时器，计数器，移位器，产生控制循环信号， 再利用74LF161A计数器和74LS194左右移位寄存器组成驱动电路来依次控制彩灯循环 闪烁。循环彩灯电路由驱动电路、输出电路、时钟电路和电源等为整个系统工作提供所 需的能源。CMOS电路对电源电压的要求相对比较宽松。循环彩灯电路是由TTL集成 电路做成，并且采用5伏电源供电。时钟电路是由555多谐自激震荡集成电路制成，与电 阻和电容一起构成时钟周期发生器，为电路提供时钟信号，支持整个电路的工作。驱动 电路是由74LF161A计数器和74LS194左右移位寄存器组成，用以驱动发光二极管正常工 作，并且在时钟电路的控制下让八个发光二极管循环工作。 关键词：八路彩灯;555定时器；计数器；移位寄存器 The Design Of Eight Lines Circulating Lights Abstract: Lights flashing and the flow can be used for a variety of decoration, such as electronic door standard^ advertising and decoration. The flow of light is always special to attract peoples attention. At night, the streets in the city, when the flow of light on the billboards up9 the city will soon get to life. I designed the lights control circuit is a very simple principle learned to use the University made several electrical knowledge. As long as several integrated circuits can easily understand its principles. Do the lights can be placed indoors, the owner will feel warm; on restaurants and other places to increase the atmosphere. Based on the electronic circuits commonly used CAD software Protel99SE designed a simple circuit lights cycle^ and the brightest lights from the light-emitting diode simulations instead. Using 555 timers, counters, shifters, resulting in the control loop signal, and then use 74LF161A around the counter and 74LS194 shift registers control drive circuit to turn lights cycling. Cycle lights circuit by the drive circuit, output circuit, clock circuit and power supply for the entire system to provide the necessary energy. CMOS circuits the power supply voltage requirements are relatively relaxed. Cycle lights circuit is made by TTL integrated circuits, and the 5-volt power supply. Clock circuit is more tha