3D打印机Z601安装流程英文版中性.pptxVIP

Z601 ASSEMBLY PROCESSNOTES： 1.Please ensure that the packaging is intact before signing. 2. After unpacking, please confirm the goods and quantity is consistent with enclosed packing list. 3. If any question, please contact our customer service immediately.ComponentsPlastic componentsLead-screw and feed rodUsed to install cradlePost-installation pictureNO: 1400MMM8 locknutM8 nutM8 shimNO: 2Install as shown below2-M8*290MM lead-screwPost-installIn the center No lockSymmetry on both side No lockNO: 3Install as shown belowIn the center No lock2-M8*290MM lead-screwNO: 4Install as shown belowIn the center （2-M8*370MM lead-screw）NO: 5Lock frame angleNO: 6Install as shown below4-M8*370MM lead-screwNO: 7Install as shown belowInsert 2 M3 nutsUsed to fix Z axis feed rod（no lock）M3*20 screw + shimNO: 8Install as shown belowM8*400 lead-screwNO: 9Put?the?components?on?No.6,?No.7?and?No.8?together?as?shown?below NO: 10Put the components on No.5 and No.9 together as shown below, and lock it.NO: 11Install M8*400 lead screw as shown belowNo lock. Calibrate after the top is installed M8*400 lead-screwNO: 12Install bearing as shown belowComponents:（M4*10 screw) bearing, aluminum sheetNo lock, need to calibrate laterNO: 13As shown below WARNING: Avoid the small steel balls slipping out from bearing 400mm feed rodNO: 14 ATTENTION:?Follow?the? directions carefully12Install?as?shown:?Lock?those ?12?M4?screw?and?make?sure? aluminum?sheet?can?move ?freely.3NO: 15Install Y axis motor and synchronizing wheel as shown belowM3 jackscrew 2PCSY axis motor3PCS M3*10 screw+ shimNO: 16Red line connect blue lineBlack line connect green lineZ axis motorNO: 17Install belt as shown belowM3*10 screw 4PCSNO: 18Install thermistor as shown belowPyrocottonThermistorTrenchinsert the thermistor according to the direction of the trench and then sealed with high-temp sealantBakeliteNO: 19Install heating plate and bakelite as shown belowNO: 20Install hot bed as shown belowFix the three boards on four