sph-常用关键字手册.docxVIP

sph-常用关键字手册 1.*C0NSTRAINED_GL0BAL 全局约束 定义一个全局平面边Purpose: Define a global boun dary con stra int pla ne. 定义一个全局平面边 界约束 Vzroble TC RT mu Y z I I I r F F fault 0 D 0 0 0 0 TC Tran slatio nal Co nstrai nt: 平动约束 EQ.1: con stra ined x tran slatio n, EQ.2: con stra ined y tran slatio n, EQ.3: con stra ined z tran slatio n, EQ.4: con stra ined x and y tran slati ons, EQ.5: con stra ined y and z tran slati ons, EQ.6: con stra ined x and z tran slati ons, EQ.7: con stra ined x, y, and z tran slati ons, RC Rotatio nal Con strai nt: 转动约束 EQ.1: con stra ined x-rotati on, EQ.2: constrained y-rotation, EQ.3: con stra ined z-rotati on, EQ.4: con stra ined x and y rotati ons, EQ.5: con stra ined y and z rotati ons, EQ.6: con stra ined z and x rotati ons, EQ.7: constrained x, y, and z rotations. DIR Direction of normal 正常的方向 EQ.1: global x, EQ.2: global y, EQ.3: global 乙 X x-offset coord in atex方向偏移坐标Y y-offset coord in ate X x-offset coord in ate x方向偏移坐标 Y y-offset coord in ate y方向偏移坐标 Z z-offset coord in ate z方向偏移坐标 Remarks: Nodes with in a mesh-size-depe ndent tolera nee are con stra ined on a global pla ne. This opti on is recomme nded for use with r-method adaptive remesh ing where no dal con stra ints are lost duri ng the remesh ing phase. 节点网格大小的依赖公差限制在全局坐标平面上， 这 个选项要求使用在 重新划分阶段。 个选项要求使用在 重新划分阶段。 举例说明：（多用在对称面处） *CONSTRAINED_GLOBA^^ CONSTRAINED GL CONSTRAINED GL X平动 Y 、Z转动X法线方向 3 4 3 Z平动 X 、Y转动 Z 法线方向 2. *SECTION_SPH SPH 属性设置 Purpose: Define section properties for SPH particles. 义 SPH 子的属 性 Card 1 1234567B Vuublt CSLH 田8 DEATH START Type AS F F F F F r Default □.dxe L.2 0.1 i.D oo U 0.0 secid SECID is refereneed on the *PART card. A unique nu mberor label not exceedi ng 8 characters must be specified. 使用特定的 PART编号，其号码字符不能超过8个字符 cslh Constant applied to the smoothing length of the particles. The default value applies for mostproblems. Values betwee n 1.05 and 1.3 are acceptable. Taking a value less tha n 1 is in admissible. Values larger tha n 1.3 will in crease the computati