塑胶模具DFM_用英文对照超级实用.pdf

. 1 和滑塊干涉的倒勾請加膠填平至 The undercut area where interfere with 滑塊可以平順滑動 slide block need to be filled material to help the slide can move smoothly 2 加膠太多 The thickening added too thick. 3 加膠面積太大 The thickening area is too wide. 4 灌點位置移位 Gate position is moved. 5 滑塊拆的位置 The split line of slide block or the area of slide. 6 此處有尖角，填充困難 This area is hard to be filled due to the sharp feature 7 此處鋼材太薄，強度不足而且不 The strength of this area is too weak and 容易冷卻 isn ’t easy to get cold due to the steel too thin 8 圓柱特徵要有一半圓不可以拆在 The semicircle of cylinder avoids 滑塊上，以免粘滑塊造成拉白， designing on slide block lest it will be 拉斷 . pulled apart or cause drag mark. 9 此處做斜銷在作動時會破壞到成 The part will be damaged if we make lifter 品 in this area. 10 這個面是裝配面，不能加膠 This is critical surface where is not allow to add material. 11 此處料位太厚，會有縮水，建議 This thick wall area might because sink 減小塑料厚度以改善 mark, Please reduce somewall thickness to improve it. 12 此處做滑塊的話會有結合線，請