Eurotherm欧陆 TE10S直流输入用户手册.pdfVIP

Industrial Solid State Contactor TE10S Static switching of resistive loads and shortwave infrared heating tubes up to 20 kW DC input User Manual © Copyright Eurotherm Automation 1996 All rights strictly reserved. No part of this document may be stored in a retrieval system, or any form or by any means without prior written permission from Eurotherm Automation SA TE10S/DC User Manual Part No. HA174780ENG Iss.1 Printed in France 07/96 EUROPEAN DIRECTIVES SAFETY The TE10S products installed and used in accordance with this User Manual are designed to comply with the essential protection requirements of the European Low Voltage Directive 73/23/EEC dated 19/02/73 (amended by Directive 93/68/EEC dated 22/07/93). MARK The CE Mark of TE10S products implies that the essential protection requirements of the European Low Voltage Directive are observed. The TE10S Technical Construction File is approved by a Notified Body, LCIE (Laboratoire Central des Industries Électriques). For further information on CE Mark, please contact your nearest Eurotherm office. DECLARATION OF CONFORMITY A CE Declaration of Conformity is available on request. ELECTROMAGNETIC COMPATIBILITY (EMC) For industrial environments, excluding residential environments The TE10S products are considered as components without any direct function as defined in the EMC Directive. The system or installation in which these products are incorporated must complies with the essential protection requirements of the EMC Directive. However, Eurotherm certifies that the TE10S products, when installed and used in accordance with their User Manual, meets the following EMC test standards and enables the system or installation in which there are installed to comply with the EMC Directive i