Eurotherm欧陆 ER-340i ER-680i ER1220i直流驱动器手册.pdfVIP

Model ER-340i / ER-680i / ER-1220i DC drive product manual HG102938 iss 8 1 This drive is an isolated 1 Quadrant speed controller for shunt wound or permanent magnet motors. It utilises speed feedback from the armature voltage (Avf), or from a shaft mounted tachogenerator. It incorporates a fully controlled thyristor bridge with a current loop to protect the drive and motor. It can be used in speed or current control modes.The drive can motor forward and will regenerate for reverse rotation by an external force. Please obtain expert help if you are not qualified to install this equipment. Make safety a priority. This component is hazardous. (All specifications in this document are nominal). ER-340i 0.55KW (0.5 HP) at 180 Volts DC, 3.4 Amps POWER RATING ER-680i 0.75KW (1.0 HP) at 180 Volts DC, 6.8 Amps ER-1220i 1.80KW (2.0 HP) at 180 Volts DC, 12.2 Amps Versions that work from 60V / 30V AC supply are also available. ER-340i / LV60, 680i / LV60, ER-1220i / LV60. For motors rated up to 48V DC Armature: 200 Volts DC. or 50V DC for LV60 models MAXIMUM OUTPUT Models ER-340i / ER-680i /ER-1220i 3.4/ 6.8/ 12.2 Amps. Field: Volts DC= 0.9 x AC supply volts. 1 Amp (0.45 x AC for field connected to F- and N). 1 Amp. 110V AC or 240V AC +/-10%, 50–60 Hz. AC SUPPLY INPUT 30V AC or 60V AC +/-10%, 50-60Hz for LV60 models. Speed range 0–100%. (motor dependant) SPEED RANGE Load Regulation typically 0.2% tach, 2%