Eurotherm欧陆 Action Pak AP4151 2000安装指南.pdfVIP

ACTIONPAKTM MODEL AP4151-2000 RTD Input, Wide Ranging, Field Configurable, Isolating Signal Conditioner Installation and Calibration Instructions Mounting Diagnostic LEDs All Action Paks feature plug-in installation. The AP4151-2000 uses Other than when executing the pushbutton calibration routine, the an 8-pin base, either the molded socket (M008) or the DIN rail socket LEDs blink under the following conditions: (MD08). An optional retaining spring (M801) is available if required for the application. GREEN: 2 Hz when the input is under range 8 Hz when the input is over range Wiring Connections Pin Signal RED: 2 Hz when the output is under range 1 AC Power (Hot) 8 Hz when the output is over range 2 Shield (GND) 3 AC Power (Neutral) An Under Range condition exists when the signal is lower than the 4 RTD Input Return operational low value minus 6.25% of the operational span. An Over 5 RTD Input (-) Range condition exists when the signal is higher than the operational high value plus 6.25% of the operational span. 6 RTD Input (+) 7 Output (+) 8 Output (-) Power Connections Power is connected according to the table above. The unit supports either 115VAC input (t