Eurotherm欧陆 Ultra SlimPak WV168安装 校准说明.pdfVIP

® ULTRA SLIMPAK II MODEL WV168-2000 True RMS AC Input Limit Alarm Installation and Calibration Instructions NOTE: The unit has been shipped with the Power Clips attached. Please remove the clips before installing the module on the DIN rail. If the Power Clips are chosen as the means to route power, they can be installed once the modules are in place on the DIN rail. DIN Rail Mounting The WV168 mounts on a 35mm TS35 DIN rail, by simply hooking until the two tabs lock firmly in place. This may require pressing on one side of the mounting foot over the rail and pressing the module the front side of the upper and lower terminal blocks for a positive towards the rail until it locks into place. To remove the unit from the fit. The board slides in where the switch and the switch position chart rail, place the tip of a flat-bladed screwdriver under the release clip on the case can be viewed together. on either the top or the bottom of the module and pry up until the module releases from the rail. See Figure 1. Figure 2 Figure 1 Description There are two standard versions of the WV168, the WV168-2000 and Wiring Connections the WV168-2001. The WV168-2000 uses standard (non-latching) relays - when a power loss occurs, the form C relay transitions to