Eurotherm欧陆 REMIO用户手册.pdfVIP

REMIO Communication interface for the TE range of power units Logic version: ‘On/Off’ operation Communication protocols: Modbus® Profibus-DP DeviceNet™ User Manual © Copyright Eurotherm 1998 All rights reserved. All reproduction or transmission in any form whatsoe ver and using any procedure (electronic or mechanical, including photocopying and recording) without written permission from Eurotherm is strictly prohibited. Ref : HA175726 ENG - Issue 2.2 - 09/2000 i CONTENTS Applicable European Directives . . . . . . . . . . . . . . . . .iii Chapter 1 Interface identification . . . . . . . . . . . . . . .1-1 Chapter 2 Wiring . . . . . . . . . . . . . . . . . . . . . . . . . .2-1 Chapter 3 Communication . . . . . . . . . . . . . . . . . . . .3-1 Chapter 4 Configuration . . . . . . . . . . . . . . . . . . . . .4-1 Chapter 5 Operation . . . . . . . . . . . . . . . . . . . . . . . .5-1 Eurotherm addresses . . . . . . . . . . . . . . . . . . . . . . . .5-6 ii REMIO/Logic User Manual APPLICABLE EUROPEAN DIRECTIVES SAFETY REMIO products are not affected by the European Low Voltage Directive 73/23 EEC dated 19/02/73 (modified by Directive 93/68 EEC dated 22/07/93). ELECTROMAGNETIC COMPATIBILITY (EMC) Electromagnetic compatibility is defined for industrial environments only, not for domestic environments. Eurotherm certifies that REMIO products installed and used in compliance with this user manual are certified compliant with the following EMC test standards. A system incorporating these products may