Gsm呼叫流程,绝对经典.pptVIP

Three Location Updating tye : Normal Location updating : used to update the regeistration of the actual LA of a MS in the Network Periodic Location Updating : to notifiy periodically the availability of the mobile in the network. This procedure is controlled by a timer (T3212) in the MS. The timer is stopped and reset to 0 when : LU accept or Reject message is received, MS has respond to a paging, MS is deactivated. IMSI Attach : to activate a MS in the Network If T3210 expires, then T3211 starts. When T3211 reaches 0, the location update procedure is restarted. If Intracell Handover is disabled, cause 15 16 are switched to cause 2 4 If repetition of Intracell Alarm is disabled, cause 15 16 are switched to cause 2 4 C10 : incremented when a successfull SDCCH Handover is completed. C15 : incremented when a RTCH channel has been successfully selected for HO Purpose C17 : incremented on the target cell when a succesffull RTCH HO is completed. C39 incremented when an SDCCH subchannel of a TS is selected by the BSS. T3107 Expiry : indicates that the intra-cell HO failed. C07 : incremented on the serving cell when a MS fails to return to the old Channel after an unsuccessfull SDCCH Handover. C08 : incremented on the serving cell when a MS fails to acess the new channel during an SDCCH HO Procedure 在原来的信道上（如SDCCH信道）收到Assignment Failure消息 Intra Cell切换过程将终止 A接口上不会有任何消息传送 BSC向BTS发RF Channel Release消息，释放新信道 Assignment Command的内容有误，手机发Assignment Failure消息到BSC Intra Cell切换过程将终止 A接口上不会有任何消息传送 BSC向BTS发RF Channel Release消息，释放新信道 T3107超时 BSC在A接口发Clear Request “Radio Interface Message Failure” BSC向BTS发RF Channel Release消息，释放新老信道 形成切换掉话 其它异常中断消息 Error Report Connection Failure Indication Release Indication Error Indication Intra Cell切换过程——异常情况 第三十页，共四十一页。 MS BTSserving BSC MSC BTStarget Meas Report Meas Result HO Alarm Candidate Cell Phys Context Req Phys Context Conf Channel Activation Channel Act Ack. HO Command HO Command HO Access HO Detection SABM Establish Ind UA