急冷油冷却器毕业设计（非常详细）.docxVIP

燕山大学本科生毕业设计（论文） 摘 要 - PAGE 4 - - PAGE 3 - 摘 要 本次课题设计的是急冷油排放冷却器，本文详细阐述了如何通过已给定的参数和工艺要求来设计一种管壳式换热器的过程。其中包括工艺计算，结构设计，强度校核及制造、检修和维护等。 首先选择换热器类型为浮头式换热器，然后进行工艺计算，得出热负荷、传热面积、筒体直径并选择合适的换热管，确定折流板间距并计算所需折流板个数，计算面积裕度并检查是否符合要求，进行传热系数校核、壁温计算及压强降计算等。然后进行换热器的结构设计及强度校核，这部分主要是管板、接管、法兰、筒体及管箱的选用及设计，同时进行补强计算，选取合适的支座。 综合考虑各种因素，确定数据的合理性，同时满足制造、检修、安装、维护等要求。最后绘制设备总图及零部件图，完成此次设计。 关键词：管壳式换热器；浮头式换热器；换热器设计；急冷油冷却器 Abstract In this paper, the design of the cooling oil discharge cooler, this article elaborated on how to have given the parameters and process requirements to design a shell and tube heat exchanger process. Including process calculations, structural design, strength checking and manufacturing, maintenance and maintenance. First select the heat exchanger type for the floating head heat exchanger, and then the process calculation, the heat load, heat transfer area, the cylinder diameter and select the appropriate heat transfer tube, determine the baffle spacing and calculate the required baffle Number, calculate the area margin and check whether to meet the requirements, the heat transfer coefficient check, wall temperature calculation and pressure drop calculation. And then the structural design of the heat exchanger and strength check, which is mainly tube plate, take over, flange, cylinder and the selection and design of the box, while the reinforcement calculation, select the appropriate bearing. Taking into account a variety of factors to determine the rationality of the data, while meeting the manufacturing, maintenance, installation, maintenance and other requirements. Finally draw the equipment map and parts drawings, to complete the design. Keywords: Shell and tube heat exchanger; Floating head heat exchanger; Heat exchanger design; Quench oil cooler 目 录 目 录 TOC \o 1-3 \h \z \u 摘 要 I Abstract II 目 录 III 第1章 绪 论 1 1.1 课题背景及研究的目的和意义 1 1.2 研究主要成果 2 1.3 发展趋势 2 1.4 存在问题 3 1.5 研究的基本内容及研究步骤 3 1.5.1 研究的基本内容 3 1.5.2 研究步骤 4 第2章 工艺计算 5 2.1