ASME B89.1.2M-1991+errata-2014 用接触比较法校正量块(直径20英寸和500毫米).pdf

AN AMERICAN NATIONAL STANDARD Calibration of Gage Blocks by Contact Comparison Methods (Through 20 in. and 500 mm) ASME B89.1.2M-1991 @ The American Society of Mechanical Engineers 345 East 47th Street, New York, N.Y. 10017 - Date of Issuance: November 30, 1991 This Standard will be revised when the Society approves the issuance of a new edition. There will be no addenda or written interpretations of there- quirements of this Standard issued to this edition. The next edition of this Standard is scheduled for publication in 1994. ASME is the registered trademark of The American Societyof Mechani.cal Engineers: This code or standard was developed under procedures accredited as meeting the criteria for American National Standards. The Consensus Committee that approved the code or standard was balanced to assure that individuals from competent and concerned interests have had an opportunity to participate. The proposed code or standard was made available for public review and comment which provides an opportunity for additional public input from industry,academia, regulatory agencies, and the public-at-large. ASME does not approve, rate, or endorse any item, construction, proprietary device, or activity. ASME does not take any position with respect to the validity of any patent rights asserted in connection with any items mentioned in this document, and does not undertake to insure anyone utilizing a standard against liability for infringementof any applicable Letters Paten