螺旋式给料机设计说明书.docVIP

PAGE 6 摘要 螺旋给料机把经过的物料通过称重桥架进行检测重量，以确定胶带上的物料重量，装在尾部的数字式测速传感器，连续测量给料机的运行速度，该速度传感器的脉冲输出正比于给料机的速度，速度信号和重量信号一起送入给料机控制器，控制器中的微处理器进行处理，产生并显示累计量/瞬时流量。该流量与设定流量进行比较，由控制仪表输出信号控制变频器改变给料机的驱动速度，使给料机上的物料流量发生变化，接近并保持在所设定的给料流量，从而实现定量给料的要求。螺旋给料器由料槽、螺旋体、轴承及驱动装置组成。螺旋体由两端轴承和中间悬挂轴承支承，由驱动装置驱动。能够满足工程生产中的要求，还能够减轻工人的劳动强度，提高生产率，实现物料输送过程的机械化和自动化 关键词： 螺旋给料器；料槽；轴承  Abstract The screw feeder measures the weight of the passing material through the weighing bridge to determine the weight of the material on the tape. The digital speed sensor installed at the tail continuously measures the running speed of the feeder. The pulse output of the speed sensor is proportional to The feeder speed, speed signal and weight signal are fed together into the feeder controller. The microprocessor in the controller processes and generates and displays the accumulated/instantaneous flow. The flow rate is compared with the set flow rate. The output signal of the control instrument controls the frequency converter to change the drive speed of the feeder, so that the material flow rate on the feeder changes, and approaches and maintains the set feed flow rate, so as to achieve quantitative Feeding requirements. Screw feeders consist of chutes, spirals, bearings and drive units. The spiral body is supported by both end bearings and intermediate suspension bearings and is driven by a drive device. Can meet the requirements of engineering production, but also can reduce the labor intensity of workers, increase productivity, realize the mechanization and automation of the material conveying process Keywords :spiral feeder; chute; bearing 目录 TOC \o 1-3 \h \z \u 1. 引言 4 2. 螺旋给料器的概述 4 2.1 螺旋给料器的基本结构 5 2.2 螺旋给料器的类型 6 2.2.1 水平螺旋给料器 6 2.2.2 倾斜螺旋给料器 6 2.2.3 垂直螺旋给料器 6 2.3 螺旋给料器的特点 6 2.4 螺旋给料器的研究现状 7 2.5 螺旋给料器的的发展趋势 8 3. 螺旋给料器工作原理及主要构件的设计和选用 9 3.1 水平螺旋给料器的工作原理 9 3.2 螺旋体 10 3.2.1 螺旋叶片 10 3.2.2螺旋轴 13 3.2.3轴承 14 3.2.4机槽 15 3.2.5驱动装置 18 4.水平给料器工作过程分