水杯盖注塑模具设计.docVIP

PAGE V 本科毕业设计(论文) 题目:水杯盖注塑模具设计 水杯盖注塑模具设计 摘 要 本课题通过对水杯盖的结构分析，设计出了一套成型模具。针对产品的结构工艺性和具体模具结构，对模具的浇注系统、成型部分的结构、脱模系统、冷却系统、注塑机的选择及有关参数的校核进行了详细的分析与设计，同时还对一重要部件编制了加工工艺。该模具采用单分型面、潜伏式浇口、一模两腔的结构，通过对整个设计过程的反复校核，表明此次设计的模具能够达到塑件的强度要求。此课题重点对制品脱出过程进行了分析，推导出动、定模之间的开模速度与制件旋出速度之间的关系，保证螺纹瓶盖塑件从模具上顺利脱出，以实现自动化提高产量。通过最终校核表明该模具能达到质量和加工工艺的要求。 关键词：自动脱螺纹；注射模具；潜伏式浇口 Design of Injection Mould for Water Cup Cover Abstract In this paper, through the analysis of the structure of the water cup, designed a set of mold. The structure of the product and the specific mold structure of the mold of the casting system, forming part of the structure, stripping system, cooling system, the choice of injection molding machine and the relevant parameters of the detailed analysis and design, but also on the An important part of the preparation of the processing technology. The mold using a single sub-surface, latent gate, a two-cavity structure, through the entire design process of repeated checks, indicating that the design of the mold to meet the strength requirements of plastic parts. This topic focuses on the analysis of the product out of the process, derived from the fixed mold between the mold speed and the relationship between the speed of the workpiece to ensure that the plastic cap plastic parts from the mold smoothly out to achieve the automation to improve production The Through the final check that the mold can achieve the quality and processing technology requirements. Key Words：auto unscrewing；injection mould；latengt gate 主要符号表 P 螺距 Ph 导程 S 螺纹长度 IT 标准公差等级 B 齿宽宽度 i 传动比 m 齿轮的模数 Z 齿轮的齿数 V 线速度 E 弹性模量 ◎ 同轴度 ⊥ 垂直度 λ 螺纹升角 ψ 螺纹形状因子 α 螺纹牙尖角 f 塑料与钢材之间的摩擦因数 [бp] 许用应力 K 修正系数 Δs 塑件公差 Qcp 塑料平均收缩率 Δz 型腔的制造公差 δs 塑件收缩波动而引起的塑件尺寸误差 Smax 最大收缩率 Smin 最小收缩率 圆柱度 对称度