防水透气膜施工方案 .pdfVIP

防水透气膜施工方案--第1页

目录

一、总则·································································································1

二、一般规定····························································································1

三、材料准备····························································································2

四、施工方法····························································································3

4.1基本做法·····························································································3

4.2细部处理·····························································································4

五、成品保护····························································································7

六、工程验收····························································································8

防水透气膜施工方案--第1页

防水透气膜施工方案--第2页

大连宏鑫建设工程有限公司防水透气膜施工方案

一、工程概况

工程名称:大连理工大学能源动力学院工程

建设单位：大连理工大学

设计单位：清华大学建筑设计研究院

监理单位:大连大工工程建设监理有限公司

施工单位:大连宏鑫建设工程有限公司

本工程为大连理工大学能源动力学院工程。工程位于大连理工大学新校区西

侧，体育场南侧。建筑面积25000平方米。质量要求为鲁班奖。建筑层数A

区为9～11层，B区为1层。结构形式为框架结构，地下部分局部有剪力墙。建

筑高度：43.90m设计使用年限：为50年。抗震设防烈度：为7度。

二、编制依据

1、《大连理工大学能源动力学院施工图》

2、国标图集《公共建筑节能构造》06J908-1

®

3、国标图集《防水透汽膜建筑构造——特卫强防水透汽材料》07CJ09

三、一般规定

3.1铺设防水透汽膜之前，应对上道工序进行质量验收，合格后方可施工。

3.2防水透汽膜沿建筑立面按高度分段自下往上顺序施工。每段防水透汽膜自上

而下铺装。段与段间按顺水方向上下搭接。如施工流水安排无法满足自下而上的

分段施工顺序，应保证防水透汽膜沿顺水方向上下搭接。

3.3防水透汽膜施工前——尤其需与基层粘贴固定前，需对基层进行必要清理、

除尘，保正施工基层平整、清洁，无尖锐突起物。

3.4宜在-5℃~40℃范围内施工（超出规定的温度范围时，可采取特殊的保温或降

温措施）。

3.5尽量避免雨中作业。如工期紧迫或遇有特殊需要，应确保