多层交换精品.ppt

* * * interface Port-channel2 switchport trunk encapsulation dot1q switchport mode trunk switchport nonegotiate no ip address ! interface GigabitEthernet0/9 description DSW121 0/9-10 -- DSW122 0/9-10 switchport trunk encapsulation dot1q switchport mode trunk switchport nonegotiate no ip address duplex full speed 100 channel-group 2 mode desirable ! interface GigabitEthernet0/10 description DSW121 0/9-10 -- DSW122 0/9-10 switchport trunk encapsulation dot1q switchport mode trunk switchport nonegotiate no ip address duplex full speed 100 channel-group 2 mode desirable ! * * * * * * * * * Purpose: This chapter introduces Point-to-Point Protocol (PPP) technologies, concepts, and configuration. Timing: This chapter takes approximately three hours to present. Note: This chapter has a laboratory exercise at the end of it. The laboratory exercise takes about 30 to 45 minutes to complete. Contents: This chapter contains the following sections: Objectives—This section explains what the students will be able to do at the end of this chapter. PPP Overview—This section overviews PPP concepts and the architecture. Configuring PPP—This section covers PPP configuration commands. Configuring PAP and CHAP Authentication—This section covers the concepts and configuration of PAP, MS-CHAP, and Challenge Handshake Authentication Protocol (CHAP). Using and Configuring other PPP LCP Options—This section presents the PPP Link Control Protocol (LCP) options callback, compression, and Multilink PPP. Verifying and Troubleshooting PPP—This section presents commands to verify and troubleshoot PPP. Laboratory Exercise—Students will configure the central site router for PPP and CHAP. Summary—This section summarizes what was taught in this chapter. Review Questions—This section offers open-ended review questions. They should foster discussion after presenting the chapter. Transition: Following are the preformance objectives that describe what students will be able to do at th