拔动开关规格书技术参数SS-12D00.docVIP

规 格 书 SPECIFICATION DESIGNATION 系列：拨动开关 MODULE NO 型号:SS-12D00 0CIRCUIT 回路： 1P2T TIMING 切换类型： SHORTING STANDARD TEST CONDTTIONS SHALL BE 5 TO 35℃ IN TEMPERATURE AND 45 TO 85% IN HUMIDITY。 温度5-35℃,湿度45-85%标准状态下测试. OPERATING TEMPERE RANGE—10 TO 60℃。 温度-10~60℃环境内使用. ITEM 项目 TEST CONDISTION测试条件 PERFORMANCE规格 6.ELECTRONICAL PERFORMANCE 电气性能 6.1 CONTACT RESISTANCE 接触阻抗 Being measured at 1kHz small current Contact resistance meter. 在1kHz小电流下测量. 30mΩ max. 30毫欧 以下. 6.2 INSULATION RESISTANCE 绝缘阻抗 Measurements shall be made following Application of Dc 500V potential Across terminals and across terminals And frame for 1 minute. 在端子之间和端子与壳之间加DC 500V 条件下,持续1分钟测量. 100MΩ max. 100兆欧 以上. 6.3 WITHSTAND VOLTAGE 耐电压 AC 500V 50Hz or 60Hz shall be Applied across terminals and across terminals And frame for 1 minute. 在端子之间和端子与壳之间加AC 500V 50Hz或60Hz 条件下,持续1分钟测量. There shall be no breakdown. 无击穿现象出现. 7.MECHANICAL PERFORMANCE 机械性能 7.1 OPERATING FORCE 动作力 Measure at the point 3mm from the tip Of the actuator knob . 在距离推杆前端3mm作测定点. 350gf±100gf 7.2 TERMINAL STRENGTH 端子强度 A static force of 500gf being applied In one direction on the tip or the Terminal for 1 minute. 一个500克之静电负荷施加于端子顶部的一个方向持续1分钟. There shall be no sign of damage mechanically and electrically. 无任何迹象显示机械及电器 性能之损坏. 7.3 ACTUATOR STRENGTH 推杆强度 A static load of 1kgf being applied In one direction of actuator for one min 一个1公斤静负荷施加于推杆之一个方向持续 1分钟. The deformation shall not be extreme and the actuator shall mechanically work normally. 推杆无变形,可以正常操作. ITEM 项目 TEST CONDISTION 测试条件 PEREORMALNCE 规格 8.DURABILITY 耐久性 8.1 SLLDERING TEST 可焊性试验 The tip of the terminals shall be dipped 2mm in the solder bath at a Temperature of 230±5℃ for 3±0.5sec. 端子顶部被浸入焊锡池2mm深,温度230±5℃ 时间3±0.5秒. A new uniform coating of solder Shall cover a minimum of 75% of the surface being immersed. 浸入的部分75%以上表面将被锡覆盖。 8.2 RESISTANCE TO SOLDERING HEAT TEST 耐焊性试验 Solder bath method Solder temperature 230±5℃ Immersion time 3±0.5scc I