Main installation should be started.doc

Main installation should be started, into the households or branch road point to check before loading in the lumen and clean. Head office with good lead wrapped in silk jute, one at the end of the flat pipe, one tube relatively fixed on the thread on the outlet, slowly turning into the clasp, grabbed a pipe wrench with a former section pipe fittings, turn the tube to a pipe wrench with another moderately elastic, aim at the tag when straightening, request thread exposed 2-3, hemp and clear it first. 4 to make horns bending, heat two Angle of 75 degrees or so, in the joint saw out of the groove, director saw into duck bill, good spelling should immediately after welding, leveling, looking for positive, straight, then welding. Claw the calibre of the elbow joint parts must be equal and head diameter, the bending radius shall be the pipe diameter is about 2.5 times. 5 shunt valve away from the branch points shoulds not be too far. If the branch is the low of the system, must before the shunt valve and drain plug. Set of tanks in and out of the gate, should be open about tank high in lower 1/3. Wire connected to the pipe straightening reinforce after installation. Put duct should be solid, such as instability can carry two clip sets tank in the end of system, should be installed, elevator. 6 adopts welded steel pipe, the pipe first chosen straightening, clean up tube chamber, tube can be shipped to site installation, the installation program from the first day. Find is the tube in place, on the nozzle to obligate mouth direction accurately, after looking for straight with gas welding spot welding spot welding under pipe diameter of 50 mm or less 3 points, 4 diameter 70 mm or more spot welding, and welding, after welding should be to ensure integrity of the pipeline. 7 steam pipe horizontal pipe should have appropriate gradient, when the slope direction and steam flow in the same direction, I 0.003 grade, should be adopted when slope direction and steam f