查看IE 浏览版本的方法.doc

查看IE 浏览器版本的方法： 转自电脑入门到精通网 点击浏览器右上方的“帮助”（部分浏览器要点击一个“齿轮”图标）→“关于 Internet Explorer”，根据弹出的窗口确定浏览器的版本。? 转自 各版本IE 浏览器清除缓存的方法： 转自 点击浏览器右上方的“工具”（IE 9 要点击一个“齿轮”图标）→“Internet 选项”，不同的浏览器将会有不同的操作方式，可参考下列示意图。 转自电脑入门到精通网 IE 9: 转自 点击“删除”，在打开的新窗口中取消勾选“保留收藏夹网站数据”，勾选其他复选框，点击“删除”即可。 转自电脑入门到精通网 转自 IE 8: 转自电脑入门到精通网 点击“删除”，在打开的新窗口中取消勾选“保留收藏夹网站数据”，勾选其他复选框，点击“删除”即可。 转自电脑入门到精通网 转自电脑入门到精通网 IE 7: 转自 点击“删除”，在打开的新窗口中点击“全部删除”，点击“是”即可。 转自电脑入门到精通网 转自电脑入门到精通网 IE 6: 转自 点击“删除 Cookies”，点击“确定”，再点击“删除文件”，勾选“删除所有脱机内容”，点击“确定”即可。 转自电脑入门到精通网 转自电脑入门到精通网 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1 hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2 supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, in