measuring eveling ruler at both ends.docVIP

measuring leveling ruler at both ends; (12) plates to allow the difference of diagonal deviation of 10 mm, inspection method for steel rule of two diagonal lines; (13) wallboard diagonal difference is 5 mm, the allowable deviation inspection method for steel rule of two diagonal lines; (14) to allow the reserved hole centerline deviation is 5 mm, test method for the feet; Reserve only electives (15) to allow the size deviation of plus or minus 5 mm, test method for the feet; (16) to allow the reserved hole centerline deviation to 10 mm, test method for the feet; (17) to allow the reserve