ppt课件-fireextinguishersfiresuppressionsystems.pptVIP

Know You SystemFire Extinguisher Suppression Activation Training Fire ExtinguishersFire Suppression Systems Inspection Maintenance Activation Procedure First-Aid Measures Personal Protection Fire Prevention Daily Inspection “Inspection” is a quick check to verify that the Fire Ext. is in the proper place in good working order. On Cartridge Operated Ext’s- check that the red stem on top of the cap is in the down position. Check to see if the plunger has been activated seal is intact. Check exterior housing and hoses for defects. Check for proper current certification stickers. Check the mounting bracket for defects. Inspection Cont. On Stored Pressure Ext’s- check that the indicator on the gauge is in the green area. If it is in overcharged or undercharged range replace unit. Inspect activation pin, seals, Inspect hose, nozzle, housing, mounting bracket. Check for proper certifications sticker. Inspection Cont. On Mobile Equipment fire suppression systems- check that the pull pin red actuator knob is in place at all activation points. Check all hoses, connection, nozzles, unit housing and mounting for defects. Check for proper certifications stickers. If any of these components are defective, get the unit checked or serviced. Before operation. Steps of a Physical Inspection of a Fire Suppression Systems Inspect all activation points. Check unit for pin, handle, safety clips Steps of a Physical Inspection of a Fire Suppression Systems Cont. Inspect hose spray nozzles for damage, kinks, or missing parts, etc. If integrity of the system has been compromised shut it down, get it fixed. Steps of a Physical Inspection of a Fire Suppression Systems Cont. Visually inspect the gas cartridges for damage. Inspect extinguisher unit for damage. Report repair any substandard units. Make sure unit has a State Fire Marshall Sticker. Maintenance “Maintenance” is a through check of fire ext’s and fire suppression systems. Maintenance is performed by qualified