ZigBee,ZDO,andZDP.pptVIP

方便可選則服務用於閱讀各種表格內所載的ZigBee節點，並請求某些公用的動作 Network Discovery Mgmt_NWK_Disc_req— implemented both to support frequency agility, which is the ability for the ZigBee network to change channels, and to help prevent PAN ID conflicts. (支援頻率靈活性，這是使ZigBee網路可以改變通道，並幫助防止PAN ID衝突) Table Management Services Mgmt_Lqi_req—the neighbor table Mgmt_Rtg_req—the routing table Mgmt_Bind_req—the (optional) binding table Informing Other Nodes to Leave the Network Mgmt_Direct_join_req —is not used much. It’s easier to simply use the network rejoin command, available through ZDO. Mgmt_permit_joining_req —can be very useful for disabling joining all throughout the network. Typically, this is the last step when commissioning a network. It closes it down to prevent other nodes getting on the network without permission.(通常，這是最後一步時，委託網絡。它關閉它，以免讓其他節點未經允許加入網路) * Starting without non-volatile memory (NVM) ensures that the node does not use anything it remembers from the last time it was booted and joined a network. 開始沒有非易失性存儲器（NVM）確保該節點不使用任何它記得從最後一次被啟動，並加入了一個網絡。 Association join (or rejoin) uses the MAC association commands to join the network. 參加協會（或重新加入）使用MAC association commands加入該網路 Rejoin with NVM rejoins the network using the same PAN and channel selected previously.重新加入網路用NVM並使用與之前相同的通道 The node may get a new short address. 可能會有新的short address The silent rejoin is very useful when nodes are reset after a battery change, or after a mains-powered network has reset after a power outage.當節點被重置後，更換電池，或在一個電源供電網絡斷電後復位。 The nodes do not actually say anything over the air, they simply start up and are capable of routing in a few tens of milliseconds. * * * End_Device_Bind_req uses an optional state machine on the ZigBee Coordinator to bind or unbind two devices. This service can be useful in a “ press-the-button-on-two-nodes-to-bind-them ” operation, useful on some Home Automation products. * Demonstrates a third-party node binding a switch to a light over-the-air. Granted, it shows the concept of Zi