1 introduction- iowa state university（1介绍-爱荷华州立大学）.docVIP

Portable Precision Soil Sampler End-Product Design Report Project Number: May05-19 Clients Dr. David Laird Darin Massner Faculty Advisor Steve Russell Team Members Jesse Bries, EE Jeremy Felker, ME Constantine Krotcov, CprE Colin Lebens, CprE Rustin Metzger, ME Mitchel Schulz EE, CprE Richard Wolf, EE REPORT DISCLAIMER NOTICE DISCLAIMER: This document was developed as a part of the requirements of an electrical and computer engineering course at Iowa State University, Ames, Iowa. This document does not constitute a professional engineering design or a professional land surveying document. Although the information is intended to be accurate, the associated students, faculty, and Iowa State University make no claims, promises, or guarantees about the accuracy, completeness, quality, or adequacy of the information. The user of this document shall ensure that any such use does not violate any laws with regard to professional licensing and certification requirements. This use includes any work resulting from this student-prepared document that is required to be under the responsible charge of a licensed engineer or surveyor. This document is copyrighted by the students who produced this document and the associated faculty advisors. No part may be reproduced without the written permission of the senior design course coordinator. Submission date: November 12, 2004Table of Contents List of Figures iii List of Tables iv List of Definitions v 1.0 Introductory Material 1 1.1 Executive Summary 1 1.1.1 Project Need 1 1.1.2 Actual Project 1 1.1.3 Results to Date 2 1.1.4 Work to be Completed 2 1.2 Acknowledgements 3 1.3 Problem Statement 3 1.3.1 Problem Statement 3 1.3.2 Solution Approach 4 1.4 Operating Environment 5 1.5 Intended Users and Intended Uses 6 1.5.1 Intended Users 6 1.5.2 Intended Uses 6 1.6 Assumptions and Limitations 7 1.6.1 Assumptions 7 1.6.2 Limitations 7 1.7 Expected End Product and Other Deliverables 8 1.7.1 End-Product Description 8 1