RBQ Burn-In Carrier Card issue record【DOC精选】.doc

RBQ BURN_IN CARRIER CARD ISSUE RECORD 1: Input pin and output pin is too loose when the handle locked. The root cause is the POGO Pin loses its elasticity. I have returned the failed test cards to vender to repair it.. 2: The fixing position plate was bending, the root cause is the assemble issue. I have returned the failure test cards to vender to repair it. 3: The operator complained to me this rack was hard to put in the put out the units. And the input lines and output lines is in disarray. I suggest design new burn-in rack such as the old UBIR Hi power burn-in rack type in the future. This morning I have done 52pcs modules experiment test, all 52pcs just have one unit slightly impression, by my checked it is acceptable. Today I will assemble one new rack to doing more experiment test to make sure the dependability. For the other 3sets will be done next week. This batch test card is our first time build, the test fixture architectural assemble is too complicated, most of failure test card are due to assemble issue. And also have design issue such as the POGO Pin type and dimensional precision and PCB layout. For these issues, I have worked with our vender to solve these issues. Next 150pcs carrier will eliminate these issue per more Hi George, This morning I have done 52pcs modules experiment test, all 52pcs just have one unit slightly impression, by my checked it is acceptable. Today I will assemble one new rack to doing more experiment test to make sure the dependability. For the other 3set racks?will be done next week. For your question 3, This batch test cards is our first time build, the main issue is the?test fixture architectural assemble is too complicated and the compact structure because our PCB size limited, most of failure test card are due to assemble issue. And also have design issue such as the POGO Pin type and dimensional precision and PCB layout. For these issues, I have worked with our vender to solve these issues. BR Kevin Hi Al