如何查看MSA1000指示灯状态.docVIP

StorageWorks Modular SAN Array 1000 LEDs Enclosure Controller Drive Fibre Channel I/O Module SCSI I/O with intergrated EMU Power Supply Enclosure LEDs Index Indicator? Condition Meaning 1 EMU Blinking Green EMU is operating normally Off EMU is not operating normally 2 Power Green System power ON Off System in STANDBY or system power has been removed 3 Fault Amber Fault detected in one or more subsystems Off No faults detected Controller LEDs During normal runtime, the MSA1000 Controller has 18 indicators that indicate activity or malfunction of the controller. Indicator Function Description 0-2 Busy status ON = Indicates this array controller is idle OFF = Indicates this array controller is operating at full capacity? 3-7? Fibre Channel ID ?Indicates the 5 bit Arbitrated Loop Physical Address (ALPA) assigned to this array controller (not applicable when in fabric mode.) 8 Idle Heartbeat? Indicates the Array controller is idle and functioning 9 Active/Standby? ON = Controller is active OFF = Controller is in standby 10 Direct Memory Access? (DMA) active ?ON = DMA transfers are active 11 Logical I/O active ON = Currently processing logical requests from the Host Adapter 12 SCSI Bus 0 active ON = Indicates requests are outstanding on the first SCSI bus 13 SCSI Bus 1 active ON = Indicates requests are outstanding on the second SCSI bus 14 Cache Activity ON = Cache active OFF = No cache activity Blinking = Cache transfer pending 15 Drive failure ON = A configured hard drive has failed in the array 16 Redundancy Active ON =? indicates two controllers are in a redundant mode of operation.? OFF = The indicator will not be lit if there is only one array controller inserted or if the array controllers are not redundant due to some type of failure. Redundant cables must be connected to enable redundancy. 17 Fault Amber indicates an error message has been sent to the controller display Top of page Drive LEDs If any Drive Fa