Touch Lens Introduction.pptVIP

Why Touch Lens ? Touch Lens Basic Spec. Touch Lens Design rule Touch Lens Process Introduction Touch Lens Process Introduction Mobile phone case with Touch Lens Touch Lens Reliability Condition * J Touch Corp. 介面光電 Touch Lens Introduction J Touch Corporation .tw Touch Lens Appearance Without housing With housing Conventional Touch Panel Application Touch Lens Application Do not need to use housing to cover touch panel edge area. Overall smoothly design in product surface. More thinner thickness than conventional TP function product. Total Transmittance : Minimum 77% Total Thickness : 1.65 +/-0.1 mm (With 1.0mm Polycarbonate) Surface Hardness : 3H Activation Force : 10 ~ 80 g Touch Lens Structure Icon sheet (Surface hardness 3H) Printing Layer Upper ITO PET Film Lower ITO PET Film Optical glue tape Polycarbonate Optical glue tape Upper ITO Film process Laminate process Icon process ITO Film Anneal Insulation ink printing Silver ink printing Insulation ink printing Cut (Roll to sheet) Protective Film Laminated Punching Alignment Hole A Clear PET Film Anneal Icon ink printing Protective Film Laminated Optical tape Laminated Punching Alignment Hole Cutting Partial Area Cut (Roll to sheet) Laminate process B ITO Film Anneal Insulation ink printing Silver ink printing Insulation ink printing Cut (Roll to sheet) Protective Film Laminated Lower ITO Film process Dot Spacer printing Polycarbonate process Polycarbonate substrate Protective Film Laminated Optical tape Laminated Assembly process Twin adhesive tape Laminated Forming (Sheet to piece) A B C Insert FPC Visual inspection Function test Packing Shipping Heat seal Visual inspection C FPC LCD Touch Lens CASE 60℃/ 90%RH *240hrs High temperature humidity test (70℃/ 0.5hr ~ -30℃/ 0.5hr) *100 cycles Thermal shock -30℃ *240hrs Low temperature storage test 70℃ *240hrs High temperature storage test Condition Item Environment Test PA R0.8mm stylus, 250gf, 100K times P