【物理】第四章实体编辑含.pptVIP

图B 显示了草图和和将要包覆的面。 图C 显示了凸起包覆特征。 图D显示了凹陷包覆特征。 图F显示刻画包覆特征。. Figure D Wrap feature created using the Deboss option Figure F Wrap feature created using the Scribe option Chapter 4 Figure B Sketch and the face selected to create the wrap feature Figure C Resulting embossed wrap feature 链接 链接 Tutorial 1 In this tutorial, you will create the model of the Plummer Block Casting shown in Figure A. The dimensions of the model are shown in Figure B. (Expected time: 30 min) Figure A Solid model of the Plummer Block Casting Figure B Dimensions of the Plummer Block Casting Chapter 4 链接 Start SolidWorks and start a new part document. Invoke the Extruded Boss/Base tool and select the Front plane as the sketching plane. Invoke the sketcher environment. Draw the sketch of the front view of the model using the automatic mirroring option to capture the design intent of the model. Add the required relations and dimensions to the sketch as shown in Figure C. Extrude the sketch using the Extrude Boss/Base tool, see Figure D. Figure C Fully defined sketch for creating the model Figure D Isometric view of the base feature of the model Chapter 4 The cut feature is created by extruding a sketch drawn on the top planar face of the base feature using the cut option. The cut feature will be extruded up to the selected surface, see Figure E for the sketch and Figure F shows the surface selection for the cut feature. Figure G shows the model after creating the cut feature. Figure E Figure F Figure G Chapter 4 To create the recess for the head of the bolt. It will be created by extruding the square sketch to a given distance using the cut option. Figure H shows the rotated model after cut feature. Figure H Cut feature added to the model Create the hole using the hole tool, see Figure I. The next feature of the model is a cut feature. To create this feature draw the sketch on the second top planar face of the base feature. The model after adding the cut feature is shown in F