中文配置文档连载.docVIP

***cisco中文配置文档连载（1） 目录： 安装向导 网络协议配置向导 --了解用户界面 --配置IP --配置IP路由协议 广域网配置向导 IBM网络配置向导 --DLSw+设置指南 --STUN配置向导 --SNA透过帧中继网 --CSNA配置向导 系统管理配置向导 --调用系统映像和配置文件 --系统管理 故障判断及排除 热点帮助 ***cisco中文配置文档连载（2） 发信站: 网易虚拟社区 (Fri Apr 16 15:08:27 1999), 站内信件 安装向导 ======== 对于每一个路由器来说,都有一个控制台接口(Console),管理员可以通过RS-232 线缆把控制口和一个终端的主口连接起来,通过这个终端对路由器进行配置. 终端通讯参数设置为: 　 　 速度: 　 9600bps 　 　 起始位: 　 1位 　 　 数据位: 　 8位 　 　 停止位: 　 1或2位 　 　 校验: 　 无 待终端通讯参数设置完毕后,接好路由器控制台,请先打开终端电源,后开路由器电 源,之后就进入初始配置了.屏幕出现(以Cisco 2501为例): System Bootstrap, Version 5.2(5), RELEASE SOFTWARE Copyright (c) 1986-1994 by cisco Systems 2500 processor with 2048 Kbytes of main memory 大约停顿1-2分钟,系统调入boot,请耐心等待 F3: 3996764+54172+225404 at 0x3000060 Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 　 　 Cisco Internetwork Operating System Software IOS (tm) 2500 Software (C2500-I-L), Version 11.2(1), MAJOR RELEASE SOF TWARE (fc1) Copyright (c) 1986-1996 by cisco Systems, Inc. Compiled Mon 30-Sep-96 12:07 by ajchopra Image text-base: 0x030215A4, data-base: 0 cisco 2500 (68030) processor (revision D) with 2048K/2048K bytes of me mory. Processor board ID with hardware revision Bridging software. X.25 software, Version 2.0, NET2, BFE and GOSIP compliant. 1 Ethernet/IEEE 802.3 interface(s) 2 Serial network interface(s) 32K bytes of non-volatile configuration memory. 8192K bytes of processor board System flash (Read ONLY) Notice: NVRAM invalid, possibly due to write erase. --- System Configuration Di