刀片相关网络技术AppA_319571_Integrity_BL8x0c_i2_FRU_RandR_20-Jan-2012.pptxVIP

  • 4
  • 0
  • 约3.99千字
  • 约 32页
  • 2017-04-04 发布于浙江
  • 举报

刀片相关网络技术AppA_319571_Integrity_BL8x0c_i2_FRU_RandR_20-Jan-2012.pptx

HP Integrity BL8x0c i2 Server Blades Appendix A: FRU Removal and Replacement Rev.12.11 HP Integrity Server Blades L200 Service and Support HP Integrity BL8x0c i2 FRU Removal and Replacement This appendix contains the removal and replacement procedures for the following FRUs: Server blade Drive Blade Link Access panels DIMMs and DIMM baffle Mezzanine cards HP Smart Array P700m/512 Controller and Backup Battery CPU baffle Processors SAS backplane System battery Base server blade replacement Server blade removal Server blade installation Remove connector covers Open the extractor lever Install the blade and close the lever Server blade remove/replace differences Integrity BL860c i2 Do NOT remove the Blade Link (BL) from the Integrity BL860c i2 before you remove the blade from the enclosure BL1 is totally unique It is purposely hard to remove so the customer does not try to remove it The bezel has a cover over the release button to protect the handle (so the customer does not accidentally remove the BL) The abutting blades in the enclosure make it almost impossible to grab/remove the handle Only remove an BL1 if it fails or if you have to remove/replace the system board Integrity BL870c i2/BL890c i2 For all versions of BL2 and BL4, you remove/replace the Blade Links while they are in the enclosure These parts are CRUs as well as FRUs SAS drive removal/installation Removal Installation Hidden slide for drive removal/installation BL1 removal 2 3 4 5 BL1 installation 3a 3c 3b BL2/BL4 removal BL2/BL4 installation Hidden slide for BL2/BL4 installation Conjoin checks Integrity BL870c/BL890c i2 systems go through a process called “conjoining” when the BL is attached The system cannot boot until that process is completed properly The following CM commands in the iLO 3 TUI show data from all blades, and therefore can be used to determine if the blades are successfully conjoined: DF—Lists the FRUs on all of the blades (2 or 4) SYSREV (or SR)—Shows a table of each blades fir

文档评论(0)

1亿VIP精品文档

相关文档