DS Pump ECU Interface_3 DS分配泵的ECU接口.pdfVIP

STANADYNE DS Pump Controls A utomotive Pump-Mounted Driver (PMD) Overview • Part Number: 39405 • Converts Digital to High-Current Pulses • Provides Valve Closure Feedback • Surface-Mount Technology • Long Inject Pulse Protection Protects Against ECU/Harness Faults • Fuel Trim Adjustment • Connector: mates with Delphi CONFIDENTIAL and PROPIETARY STANADYNE DS Pump Controls A utomotive PMD Control Signals CONFIDENTIAL and PROPIETARY STANADYNE DS Pump Controls A utomotive PMD Interface Battery Power: Pin D Power for the PMD is supplied through the Battery Power terminal. Leads and connections to this input must be sufficient to carry the solenoid current for the driver circuitry. Power Ground: Pin F The Power Ground terminal will sink all PMD driven loads and is connected to the DS Pump cover, which is electrically connected to vehicle ground via its wiring harness. Inject Command: Pin A The PMD will interface with the Inject Command signal from the vehicle engine controller. The PMD will initiate current to the solenoid valve when the Inject Command line goes high and terminate current when the signal goes low. High Level: Vih = 3.3v min Low Level: Vil = 0.9v max Input Impedance: 10 Kohm || 1000 pfd Maximum Input Voltage: -29 to +29 v continuous In the event of an Inject Command signal failing to go low, the PMD wil