Reform of vocational SCM.docVIP

Reform of vocational SCM Abstract: The microcontroller is a vocational course in electrical engineering and automation of the important course, has a strong comprehensive, practical and so on. Based on the current status of vocational teaching microcontroller, teaching and application for the existing MCU problems , combined with my years of teaching experience, gives some instruction on the SCM reform. Keywords: Electrical Engineering and Automation; microcontroller, teaching reform Introduction SCM After years of development, a great improvement on the performance, in the models developed to thousands of species, have been widely applied to all areas of society, SCM is a vocational course in electrical engineering and automation of the important course, but compared to the teaching of microcontrollers in many ways to follow commonly used in general secondary schools teachers teach knowledge-based teaching model, emphasizing the integrity of the system of theoretical knowledge, rigor. As for the theory and practice of knowledge associated with the study is the weakness of vocational students, the traditional knowledge of SCM SCM structure of teaching is the main line, the knowledge system is divided into single chip hardware architecture, instruction set, software programming, microcontroller system expansion and application of a variety of peripheral devices. teach the order of the hardware structure Instruction Software Programming SCM system expansion and application of a variety of peripheral devices, and finally revisit some examples. Under this teaching structure, students generally was difficult to learn, resulting in most of the students had the weary, made the teacher complained that students are now more and more difficult to teach, and students complain about the theoretical knowledge of the teacher boring, nothing to understand, so a vicious cycle. how to make the basis of weak students to better grasp the SCM SCM technology is curre