- 1、本文档共5页,可阅读全部内容。
- 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
- 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
超载高度及软土层厚度对卸载标准影响研究
学兔兔
第39卷,第2期 公 路 工 程 Vo1.39,No.2
2 0 1 4年 4月 Highway Engineering Apr.,2 0 1 4
超载高度及软土层厚度对卸载标准影响研究
李 红 ,韩尚宇 ,祝 磊
(1.南昌大学 科学技术学院.江西南昌 330029; 2.南昌航空大学 土木建筑学院,江西 南昌 330063; 3.淮
委水利科学研究院,安徽蚌埠 233000)
[摘 要】根据“佛山一环”沉降观测数据和地质勘查资料,通过模拟分析不同预压载荷、软土层厚度下路基土
的沉降变形规律,对排水固结法处理路段的卸载标准问题进行分析。结果表明,满载预压时间相同时,累计沉降量
和沉降速率随超载高度、软土层厚度的增加而增大;增加超载高度能缩短预压时问,根据剩余沉降量确定卸载标准
时应考虑载荷增加对路基计算深度的影响;排水体系正常工作条件下,等载预压满6个月、沉降速率小于5 ram/
月,工后沉降通常小于300 am;当欠载高度超过1 m时,单靠延长预压时间难以使路段的工后沉降量满足要求。
【关键词]卸载标准;超载高度;软土层厚度;有限元模拟
【中图分类号]U 416.03 [文献标识码]A [文章编号】1674-061o(2014)02—0009—04
Study of Unloading Control Standards under Different Preload
Height and Different Soft Soil Thickness
LI Hong‘, HAN Shangyu ,ZHU Lei
(1.Nanchang University College of Science and Technology,Nanchang,Jinagxi 330029,China; 2.
College of Engineering and Architecture,Nanchang Hangkong University,Nanehang,Jiangxi 330063,
China; 3.Huaihe Water Resources Commission,Bengbu,Anhui 233000,China)
[Abstract]Combined with the settlement observation data of Foshan one ring road,by the way of
settlement simulation of different preload height and different soft soil thickness,the unloading control
standards for the section treated by drainage consolidation method was studied in this paper.Based on
these results,some useful conclusions are drawn from the discussion and analysis.The total settlement
and post-deposition settlement velocity increases with the raise of preload height and soft soil thickness in
the condition of preloading time equality.Raise the preload
文档评论(0)