cisco4506简版交换机配置维护手册(国外英文资料).docVIP

cisco4506简版交换机配置维护手册(国外英文资料) The Switch# show IP interface gigabitethernet0/2 Configure a set of ports All ports in the same group must be in the same category. 4506 # configure terminal enters the configuration state 4506 (config) # interface range of thernet2/1-5 enters the port configuration state. 5506 (config-if-range) # no shutdown The following example shows groups using commas to configure different types of ports: 4506 # configure terminal enters the configuration state 4506 (config) # interface range of thernet2/1-3, gigabitethernet3/1-2 enters the port configuration state. 5506 (config-if-range) # no shutdown Configure the rate of the second layer port and the dual mode 4506 # configure terminal enters the configuration state 4506 (config) # interface: thernet2/3 enters the port configuration state. 4506 (config-if) # speed 10 sets the port rate The config-if # duplex full Config -if # description Marketing # 4006 (config - if) end 5506 (config) # show interfaces thernet0/4 4506 (config) # copy running - config startup - config Configure three mouth 4506 # configure terminal enters the configuration state 4506 (config) # interface gigabitethernet3/2 enters the port configuration state4506 (config-if) # no switchport turns the physical port into three levels The config -if # IP address 192.20.135.21 255.255.255.0 configures the IP address and mask 4506 (config-if) # no shutdown activation port 4506 (config-if) # end exits 4506 (config) # show running - config interface gigabitethernet3/2 authentication configuration 4506 (config) # copy running - config startup - config saves the configuration 4506 # show IP interface gigabitethernet3/2 Close and open the port Switch# configure terminal Switch (config) # interface is thernet2/5 The Switch (config - if) # shutdown The Switch (config - if) # Switch# configure terminal Switch (config) # interface is thernet2/5 Switch (config-if) # no shutdown Configuration VLAN Switch# configure terminal 20 # vlan Switch (co