20170221空心钢管混凝土柱滞回性能数值模拟.docx

摘要本文通过数值模拟与参数分析主要研究圆形和方形两种截面形式的空心钢管混凝土柱在较高轴压比情况下抗震性能。建立了空心钢管混凝土柱的分布塑性纤维模型和三维塑性有限元模型，对比验证了纤维模型法计算结果、有限元法计算结果及试验结果，结果表明了本文建立的空心钢管混凝土数值力学模型的正确性。通过数值计算分析轴压比、空心率、长细比、混凝土强度、含钢率、钢材强度及截面形式对空心钢管混凝土柱骨架曲线的影响，为确定空心钢管混凝土结构抗震设计方法提供理论依据，供实际工程设计和分析参考。关键词空心钢管混凝土；滞回性能；数值模拟；参数分析ABSTRACTThispaper mainly studied theseismic behavior of H-CFST by numerical simulation and parameters anaylsis, whichinvolves circular and quadrate cross sections, under higher axial compression ratio. The numerical models(distributed plastic fiber model and three-dimensional plastic finite element model) of H-CFST frame column werebuilded and the numerical calculation were in good agreement with test results. The influences of axial compression ratio, hollow ratio, slenderness ratio, concrete strength, steel ratio, steel strength and section form to the skeleton curves of H-CFST were studied by numerical calculation, which will provide theoretical foundations forseismic design of hollow-concrete-filled steel tubular structures as well as reference fordesign and analysisof practical engineering. KEY WORDShollow concrete-filled steel tube; hysteresis behavior; numericalsimulation; parameters anaylsis目录CONTENTS1Introduction11.1Background, purpose and significance of the subject11.2Present research and analysis about the related subjects31.2.1Research status in China31.2.2Abroad research status101.3Research contents and method in this paper112 Building and verification for numerical model on hysteresis behavior of H-CFSTcolumns132.1Introduction132.2Stress-strain curve of core conrete in H-CFST132.2.1Confinement coefficient of core concrete in CFST142.2.2Uniaxial stress-strain relationship of core concrete142.2.3Stress-strain relationship of core concrete for Abaqus152.3Building and verification for numerical model of H-CFST162.3.1Fiber model162.3.2Finite element model192.3.3Comparison between numerical and test results203Parametersanaylsison hysteresis behavior of H-CFST columns293.1Introduction293.2Influence ofax