在硬盘驱动器上部署 Windows RE 映像（国外英文资料）.doc

在硬盘驱动器上部署 Windows RE 映像（国外英文资料） Operation instance: deploy the Windows RE image on a hard disk drive Update time: May 2009 Application: Windows 7, Windows Server 2008 R2 This action example shows how to deploy the Windows (R) recovery environment (Windows RE) solution on a hard disk drive. Windows RE supports multiple recovery scenarios. This topic introduces two sample recovery solutions: based on setup recovery and self-definition recovery. In Windows? In 7, you can install Windows RE images in any partition that meets all the requirements: ? Must be one of the following partition types: O MBR disk - type 0x7 or type 0x27. If it is type 0x27, it must be at the beginning of the disk. O GPT disk - contains the PARTITION_MSFT_RECOVERY_GUID attribute. ? Must be a primary partition. ? The NTFS format must be adopted. ? You must be on the same disk that contains the Windows installation. For other partitioning options, see the disk partition. An installed recovery solution The installation solution will reinstall the operating system using the supplied image file (install.wim). If a failure occurs, the end user can choose to reinstall the factory image. In this case, you will create three partitions. Partition 1 partition 2 partition 3 System/Windows RE (activity) Type 0 x27 300 megabytes (MB) Windows 7 Type 0x7 factory image file (install.wim) or third-party recovery solution Type 0 x7 A prerequisite for To complete this operation instance, you need the following conditions: ? A bootable Windows PE medium with ImageX tools, such as cd-rom or USB flash drive (UFD). See the Windows PE operation instance. ? A target computer with a hard drive will deploy Windows 7 and custom Windows RE on the drive. ? A reference Windows 7 image stored in an external location, such as a network Shared or external USB hard drive. Step 1: partition the hard drive In this step, use Windows PE to start the target computer, configure the hard disk, and deploy the Windows 7 image. Start the tar