开关电源1234（国外英文资料）.doc

开关电源1234（国外英文资料） General consideration of switching power supply design Switch power source, design Before designing the power supply, study the requirements of the power supply. An example of a communication power module is used to illustrate the design considerations. The technical specifications for the module are as follows: 1 electrical properties Unless otherwise specified, all the parameters in the input voltage is 220 v, ac 50 hz, and environmental temperature 25 ℃ under test and the rules. 1.1 input Voltage: single phase ac rated voltage is 220V plus or minus 20% Frequency: range 45-65hz Current: when fully loaded, enter 220V, less than 8A. At 264V, the shock current is not greater than 18A Efficiency: the load is 50% to 100% table 2.1 Power factor: greater than 0.90, load above 50%, above 0.95 Harmonic distortion: comply with IEC 555-2 requirement Start-up delay: the output of the power supply within 3 seconds of the power supply is rated Keep time: enter 176V valid value, full load, greater than 10mS 1.2 the output Voltage: when fully loaded, the output voltage is set at plus or minus 0.2% of the value of the table 1 Current: load current from zero to maximum (see table 1). Flow protection begins with constant current, when the voltage is reduced to something worthwhile, the current is cut off. Voltage stabilizer: load change from zero to 100%, input voltage from 176V to 264V. The output voltage change is no more than 200mV. Transient response: when no battery is connected to the output, load changes from 10% to 100%, or by the load change by 10%, the recovery time should be within 2 ms. The maximum output voltage deviation should be less than 1V. Static leakage current: when the module is off, the maximum reverse leakage current is less than 5mA. Temperature coefficient: the module is less than 0.015% of the total working temperature. Temperature drift: in the first 30 seconds, plus or minus 0.1% Output noise: the output noise meets the communication pow