四重铝箔轧机工作辊辊形曲线的优化.pdfVIP

第34卷第7 期 东北大学学报(自然科学版) Vo 1. 34 ,No.7 2013 年 7 月 Journal of Northeastern University( Natural Science) Ju1. 2013 四重铝结轧机工作辘辘形曲线的优化 龚殿尧1 ，徐建忠1 ，邸洪双1 ，雷银娥2 (1.东北大学轧制技术及连轧自动化国家重点实验室，辽宁沈阳 110819; 2 徐州四方铝业集团，江苏徐州 221007) 摘 要:针对国内某四重铝情轧机生产装饰宿时出现的二肋浪形问题，根据板形理论分析认为宿材轧制 中产生二肋浪形的原因是工作辑对应区域的等效凸度过大.分析了热膨胀和冷却、工作辘粗糙度和工作辑曲 线等因素对工作辑等效凸度的影响，确定现场条件下影响工作辑对应区域等效凸度的主要因素为工作辐曲 线参数，参考相关文献推导了铝宿轧机工作辘曲线表达式，对采用不同凸度、不同半角时的工作银曲线进行了 对比，从中选出适合当前工况下的工作辘曲线.采用该工作辘曲线进行现场实验，实验结果表明通过提高工作 程曲线半角角度可使二肋浪问题得到解决. 关键词:铝韬轧机;四重轧机;二肋浪;工作辘曲线优化;影响函数法 中图分类号: TG 335.5 文献标志码:A 文章编号: 1∞5 -3026(2013)07 -0952-04 Optimization of Working Roll Curve of Four-High Aluminum Foil Rolling Mill 1 1 GONG Dian-yω1， , XU Jian-zhong , DI Hong-shzωng ， LEI 盯nJ (1. State Key Laboratory of Rolling and Automation , Nortbeastem University , Shenyang 110819 , China; 2. Xuzhou Sifang Aluminum Co. , Ltd. , Xuzhou 221007 , China. Corresponding author: GONG Dian-yao , E-maiI: gongdy@ral. neu. edu. cn) Abstract: Aim at the double-rib wave problem which happened during rolling decoration foil production using a four-high mill in certain domestic factory , according to the shape control theory , this kind of strip shape obtained due to 出e equivalent convexity in the corresponding area of the working roll was excessive. The effects of the factors such as thermal extension and cooling , the roughness and the curve of the working rolls on 出e equivalent convexity were analyzed. The key factor affected the equivalent convexity of the co盯esponding area of the working rolls in 由e worksite.τhe expression equations of the cu凹e of the working roll was deduced based on references , and th