注塑成型工艺常见问题整理(国外英语资料).docVIP

注塑成型工艺常见问题整理(国外英语资料) Injection molding machine can not shoot how many kinds of reasons, how should we deal with? 1 the nozzle is blocked and the nozzle is removed and fired until the nozzle is clear 2 the heating ring is broken 3 screw off, change the screw 4, the nozzle temperature is not enough, the heating Thats about it How about the injection position of injection molding machine? Only two segments of plastic, less a paragraph and three paragraph, product note dissatisfaction, is not the location is not adjusted well? How do I adjust the position? Best answer You see, is not the location of the sol enough ah, that is not enough gum ah, so simple, but also ask whether you are an apprentice ah? The position of the gel at the first stage shall not be greater than the sol position. I dont understand this How to set three injection position and five segment position of injection molding machine? How about setting the holding time? Best answer Injection position of injection molding machine should start from the sol position, we must first determine the location of sol you, you have three or five injection of words, that is not a position higher than two sol position, position cannot be greater than a section of the location, location can not be three greater than two segment position and so on! Cannot finish writing! Add me (urgent) injection molding machine glue, more than the glue less than the set position Injection molding machine glue more than glue less than set position ~ what is the problem ~? Expert solution please! Run the origin position and reset the origin OK How about the injection position of injection molding machine? Only two segments of plastic, less a paragraph and three paragraph, product note dissatisfaction, is not the location is not correct? How do I adjust the position? Your first position is not transferred than the glue is also a large position, ah, the third section of the position can be adjusted to 1 ah?. One, two, three, the location o