65Mn钢板淬火后硬度不均原因分析.pdfVIP

鞍 韵 技 术 2016年第5 期 ANGANG TECHNOLOGY 总第401期 ( 生 户 卖 咸 〉 65Mn钢板淬火后硬度不均原因分析 高暴、杨玉\马明1 ( 1.鞍钢股份有限公司产品发展部，辽 宁 鞍 山 4021; 2 , 鞍钢集团钢铁研究院，辽 宁 鞍 山 4009) 摘要 ：针 对65Mn钢圆锯片淬火后破度不均现象进行了研究_。对锯片的化学成分、原始组 织及淬火后的组织和硬度进衧了分析，结果表明，钢板化学成分满足标准要求，但存在明显的 带状偏析，分析认为带状偏析是造成65Mii银片淬火硬度不均匀的主要原因，同时提出了相应 的改进措施.D 关键词：65Mn钢板;硬度不均；带状偏析；显微组织 中图分类号：TG142 文献标识码：A 文章编号： 1006-4613(2016)05-0053-04 Analysis on Causes Leading to Non-uniform Quenched Hardness of 65 Mn Steel Plate Gao Lei1, Yang Yu2, Ma Ming1 (1. Product Development Department of Angang Stelel Co ., Ltd ., Anshan 114021, Liaoning , China ; 2. Iron Steel Research Institutes of Ansteel Group Corporation , Anshan 114009,Liaoning ,China ) Abstract ： The study on the phenomenon of non-uniform quenched hardness of a circular saw blade made by 65 Mn steel was carried out . The chemical compositions , original microstructures , quenched microstructures and hardness on the part of the blade were analyzed . The analytical results showed that the chemical compositions of the blade met the requirements specified in the specification , but there was remarkable band segregation . According to the analytical results it was believed that the band segregation was the main causes leading to non-uniform quenched hardness of the blade and then the corresponding improving measures was proposed . Key words ： 65 Mn steel plate ； non-uniform hardness ； band segregation ； microstructure 金刚石圆锯片是生产大理石板材的主要工具 显不均，硬度低处只有40(HRC ),硬度高处可达 之一，而 65Mn钢板是制造金刚石锯片基体的主 60(HRC )，严重影响成品合格率c 为查明淬火后硬 要材料，我国每年用