北京航空航天大学 材料力学课件 Chapt8-2004（国外英文资料）.docVIP

北京航空航天大学 材料力学课件 Chapt8-2004 This article is contributed by KedanJ Ppt documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Chapter 8 Strength Analysis of Complex State of Stresses complex stress state strength, 1 Introduction 2 Criteria of Fracture on the fracture strength theory, 3 Criteria of Yield on the yield strength theory of section 4 Application of strength criteria 5 Combined application of strength theory deformation problems involving bending tension (compression) and twisting bending and bending (combined compression and torsion deformation and bending pressure) 6 Strength of thin-walled circular cylinders under internal pressure thin cylinder confined strength calculation section 7 Mohr Criterion Mohr strength theory, torsion deformation Section 1 Introduction introduction Strength problems of complex state of stresses Modes complex stress intensity of failure of of materials under static load material static load damage in the form of material damage in the form of static load strength theory Criteria strength theory of materials Failure Strength, problems, of, complex, state, of, stresses Complex stress state strength problem Uniaxial stress and pure shear General complex stress state Sigma = max Sigma u N R Max U N A U, u tau by testing The ultimate stress, the ultimate stress of each ratio case, is difficult to determine by the test In this chapter, the law of failure or failure of materials under static complex stress and its application to strength analysis of members are studied Modes, of, Failure, of, materials, under, static, load Material; static loading; failure mode; static loading; failure mode Phenomenon:, Failure, by, Lost, Strength - Rupture, or, Yield Plastic material, brittle material Crack Crack Preliminary analysis of yield or slip may be caused by excessive Max fracture fracture may be a t failure forms and causes, Max or epsilon T, caused