叉车理论试卷 2（国外英文资料）.docVIP

叉车理论试卷 2 Judgment question 1: motor vehicles are widely used in DC generators and alternators. (to) 2: Public Security Bureau issued license plates and driving permit vehicles, you can travel in the factory. (to) 3: cylinder block is the foundation of the engine. (to) The 4: piston pin is in interference fit with the piston pin housing. (wrong) The 5: drive axle transfers the power input from the transmission to the drive wheel at last. (to) The 6: ZL loader adopts articulated frame. (to) The main function of the 7: hand brake is to reliably stop the vehicle in the parking position without slipping and can act as an auxiliary brake when necessary. (to) The lifting lever of 8: forklift truck is a control element. (to) 9: storage battery vehicles can use 24 - 48 volt batteries. (to) The 10: water temperature meter is used to indicate the temperature of the cooling water in the jacket when the engine is running. It is expressed in degrees centigrade. (to) 11: before starting the engine, you should tighten the hand brake first, then shift the lever into neutral. (to) When the 12: vehicle turns, the outer rear wheel is larger than the outer front wheel radius, and their difference is called the inner wheel difference 13: vehicles are not allowed to use emergency braking and speed change on the long steep ramp. (to) 14: operation, metal percussion sound, leak sound, carburetor exhaust pipe, put guns, show that the engine abnormal sound. (to) The common failures of the braking devices of 15: motor vehicles are heavy steering, vehicle sway and driving bias. (wrong) 16: single brake shoe and brake drum gap is too small, braking, vehicle deviation. (to) The piston of each pump of 17: diesel engine has interchangeability. (wrong) 18: the oil mist ejected by the injector must have some pressure. (to) 19: an engine has three types of oil filters. (to) The piston of the 20: four stroke internal combustion engine moves one stroke in the cylinder, and the crankshaft rotates 180o ac