电气工程施工中所遇问题汇总（国外英文资料）.docVIP

电气工程施工中所遇问题汇总 First, lightning protection grounding does not meet the requirements 1, phenomenon (L), lead, equalizing ring, lightning protection belt joint slag, welding, weld, weld undercut, not full of defects. (2), no welding slag on the knock, lightning with weld brush rust. (3) use whorl steel instead of round bar for lapping steel bar. (4) make use of the main reinforcement welded by the butt welding directly for lightning protection. 2, cause analysis (1) the operator is not strong in responsibility and the welding technique is unskilled; most of them are all versatile welders in the electrical engineering class, and their welding skills are poor. (2) site construction administrator on national construction and acceptance norms GB50169 2, grounding device the relevant provisions of the implementation of inadequate. 3, preventive measures (L) strengthen the training of welders skills, and require that the welds in the lap welds be full, smooth and uniform, especially for welding with higher difficulty, such as welding and reverse welding. (2), strengthen management and welder responsibility, timely repair welding unqualified, and promptly knocked off the welding slag, rust proof paint brush. (3) GB50169 2, according to the provisions of the electric equipment installation engineering code for construction and acceptance of grounding device, lightning deflectors are connected to lap welding, lap length is 6 times the diameter of the result, do not allow the use of thread steel instead of steel for the reinforcement lap. In addition, as the main reinforcement of the lead wire, if it is butt welded, the welded joint shall be filled with round steel according to the regulations. Two, the outdoor household tube pretreatment does not meet the requirements L phenomenon (1) the thin-wall copper pipe is used instead of the thick wall steel tube. (2) the depth of embedment is not enough and the location deviation is great. (3) the arc welding is made at the turning poi