底盘-传动系统（Chassis - drive system）.doc

底盘-传动系统（Chassis - drive system） What kind of control is shift-by-wire? (indefinite item selection) A. There is A mechanical connection between shift lever or shift balance and gearbox B. Adjust the motor in the electronic throttle C. the shift signal is transmitted electronically to the SMG control unit D. Electronic clutch connection control C There is a accumulator in the SMG gearbox. What is the normal pressure of the accumulator? (indefinite item selection) A. 25 bar B. 30 bar C. 40 bar D. more than 50 bar D The following options for the SMG gearbox are correct. A. The accumulator is composed of A free movable piston and two empty cavities B. The accumulator is composed of two movable pistons C. an empty cavity filled with nitrogen D. 2 cavity filled with hydraulic fluid AC What measures should be taken when the SMG control unit fails? (indefinite item selection) A. Should confirm whether it is on the stall B. The car can be towed directly C. If its empty, you can tow it D. The driving wheel is towed ACD What are the components of the hydraulic control group of SMG? (indefinite item selection) A. 4 shift stroke valve for control of hydraulic control cylinder B. 2 pressure control valves for shifting force modulation C. 4 hydraulic control cylinders for moving the fork shaft along the longitudinal axis D. 3 brake for gear control ABC SMG clutch position sensor (PLDC)? (indefinite item selection) A. Monitoring of the location of the clutch B. Determine the accurate clutch sliding point according to different engine and gearbox speed C. Update the clutch sliding point in the SMG control unit D. Provide reference for SMG shift points ABC The SMG control unit is used to identify the upper slope according to the signals of the following parts. A. Longitudinal acceleration sensor B. Deflection sensor C. Wheel speed sensor D. Accelerator pedal position ACD The control logic of SMG when the high speed brake is at rest. The units MG control unit is able to recognize the r