监理细则01（Supervision rule 01）.docVIP

监理细则01（Supervision rule 01） Overall green supervision rules I. professional characteristics of vegetation planting and construction matters needing attention 1. Pruning before planting (1) seedling root should be pruned before planting, so it is appropriate to cut the root of the root, the root of the disease, cut off the root of the root, and trim the crown of the tree to keep the ground balanced on the ground. (2) bulbous and bulbous shrubs can be branched and ball-shaped control. (3) branched branches, small shrubs with buds of new branches, should be properly pruned by the tree potential. The green seedlings start to dig The quality of the seedling can directly affect the planting of trees and the future greening effect. According to different trees and tree age, planting season, transportation, soil quality, etc., the following three methods: (1) bare-root digging: mainly used for resting deciduous Joe, shrub, and rattan. (2) excavated seedlings of the old soil: mainly suitable for small, easy to carry shrubs. (3) excavating seedlings of mud pellets: mainly used in evergreen trees and more difficult trees. 3. Excavation of planting holes (1) planting hole, the fixed line of the slot shall conform to the requirements of the design drawing, the position must be accurate, the marks are obvious and should be recognized by the supervision engineer. (2) location of planting point should be marked with focal point. The designated mark shall indicate the name (or code) of the tree and the specification. (3) when the location of qiao mu is affected by obstacles, it shall contact the design unit to make appropriate adjustments. After planting the hole, notify the supervising engineer to check the process. (4) the size of the excavation shall be determined according to the diameter of the earth and the soil conditions. The hole must be dug vertically and the bottom is equal to the bottom. The specification is in accordance with the following table: Flower shrub planting h