13、【技术交底】之楼地面工程（13, [technical disclosure] floor works）.doc

13、【技术交底】之楼地面工程（13, [technical disclosure] floor works） Project background: the explanation for the project for cast-in-situ reinforced concrete frame shear wall structure building of bean Shilou ground engineering, engineering construction area of 46527 square meters, 33 floors. Position: floor Time of issue: October 15, 2009 Disclosure content: 1. Material requirements: 1.1, cement with 32.5 Portland cement, Portland cement (by the same manufacturer, the same species, the same batch, the same strength grade products), must be inspected in accordance with the relevant provisions before entering, qualified rear can use. Shall not use the poor stability or just out of the kiln hot cement (coagulation, hardening, shrinkage). 1.2, stone by stone hard, the diameter of 3-6mm and mud content is less than 3% of the Guami stone, the design should be appropriate, particles less than 0.2mm should be sifted (must be inspected in accordance with the relevant regulations, before entering), before use should be clean. 1.3. Methyl cellulose: double five brand methyl cellulose adhesive or easy brand PHC bonding mortar admixture. 1.4, the water should be drinking water. 2. mixing ratio and mixing system 2.1, Guami stone surface layer thickness according to the requirements of general office shall not be greater than 20mm. 2.2, Guami stone slurry mix 1:2.5 compounding ratio according to J312 standard atlas of the southwest, different varieties, the strength of cement should not be mixed (setting time and hardening shrinkage was different). Water cement ratio should be controlled within 0.4, reducing shrinkage. 2.3, Guami stone slurry mixing must adopt mechanical agitation by artificial mixing may, mixing must be uniform, stirring time of not less than 1min. The raw materials Guami stone slurry should be strict measurement. Measurement method should adopt pound weighing method and shall not adopt volumetric method. 2.4, interface processing agent preparation Preparation of 2.4.1 and m